There is a trade-off between the maximum particle size of stainless steel wire mesh products. But the size of the sieve openings originated from the adoption of sieving segments and requests for cargo size.
In the stainless steel wire mesh, the size of the sieving holes after the sieving is normal. The larger the size of the sieving opening of the crusher and its sieve holes, the higher the consumption rate of the sieve surface of the department and the higher the screening frequency. The sieve size of the screening screening should originate from the maximum size of the final crushed minerals requested, and its value is generally larger than the discharge port of the tricycle. The detailed value should be affirmed by the load rate of the crusher.
When the stainless steel wire mesh does not contain particles larger than the regular size, the regular size should be used as the screen size. When the product on the sieve is requested to contain too few fine particles, a larger sieve opening should be adopted; on the contrary, if the product on the sieve is requested, it can be used as much as possible.